Hover over main image to zoom
BEAUTY OF WOOD. DURABILITY OF PVC.
The VERSATEX Canvas Series has been developed to add contrast to your porch ceilings and interior trim projects.
This innovation combines an exterior grade laminate featuring warm woodgrain finishes with long-lasting,
maintenance-free VERSATEX profiles. Through the Canvas Series, VERSATEX delivers the look of rich hardwoods
without knots and without labor-intensive re-staining requirements.
Actual size: 1/2"x6"x18'
VERSATEX Sheet and Beadboard 1/2" or thinner are not designed to be ripped and used for trim applications. These products must be glued and mechanically fastened to the substrate.
Use 1" nominal beadboard products or thicker boards for spans of 16" to 24".
When using VERSATEX 1/2" Beadboard or 1/2" thick VERSATEX sheet, orient it perpendicular to the joists. Fasten every 12" or less on center and apply construction adhesive to the under side of the rafters.
Never span VERSATEX more than 24".
Before installing VERSATEX Beadboard, be sure the underside of the ceiling joists are true and level. You may want to place a 1/2" or 7/16" sheet of OSB or plywood to the underside of the ceiling joists to reduce or eliminate joist read through.
* NOTE: ADHESIVES AND ACETONE CAN DAMAGE THE APPEARANCE OF CANVAS SERIES PRODUCTS! DO NOT USE FOR INSTALLATION. • All Canvas Series products are to be
handled like you would a stained piece of mahogany, walnut or any other premium wood and not like dimensional lumber. Keep the product on a skid and covered until time of installation.
The faux stained pieces should never be stored on the ground, on asphalt, or on any rough surface face down. Boards should be removed from skids by lifting at both ends when possible—friction
between laminate and bare board may cause minor marking. See cleaning tips for removal method. • Refer to porch ceiling installation instructions in the VERSATEX Contractor Handbook
for recommendations and best practices. • Use matching end cut coating applicator for cut board edges and wax stick nail hole filler to cover exposed fastener holes. CLEANING CANVAS SERIES •
Wipe material with gentle cleanser like Simple Green cleaner and a soft cloth. • If marking occurs from board-to-board friction, WD-40, Pledge, and Armor All can also be used but will require
extra wiping to prevent leaving shiny residue. WARNING: DO NOT use abrasive scrub pads like Scotch Brite pads or any solvent like acetone and toluene! They will break down the laminates
and dull the surface